South African Class GH 4-6-2+2-6-4
39 ft 6+1⁄2 in (12,052 mm)
25 LT 14 cwt (26,110 kg) rear
12 LT 17 cwt (13,060 kg) rear
2,350 imp gal (10,700 L) belly
26 in (660 mm) stroke
Performance figures | |
---|---|
Tractive effort | 44,490 lbf (197.9 kN) @ 75% |
Career | |
---|---|
Operators | South African Railways |
Class | Class GH |
Number in class | 2 |
Numbers | 2320-2321 |
Delivered | 1928 |
First run | 1928 |
Withdrawn | c. 1958 |
The South African Railways Class GH 4-6-2+2-6-4 of 1928 was an articulated steam locomotive.
In 1928, the South African Railways placed two Class GH 4-6-2+2-6-4 Double Pacific type passenger versions of the Class U Union Garratt articulated steam locomotive in service. The Union Garratt design embodied the Garratt design at the front end and the Modified Fairlie design at the rear end.[1][2][3][4][5]
Manufacturer
The Class GH, the heavy passenger version of the Class U Union Garratt, was designed and built by Maffei in Munich, Germany, to the specifications of Colonel F.R. Collins DSO, Chief Mechanical Engineer of the South African Railways (SAR). Two locomotives were delivered in 1928, numbered 2320 and 2321. They were erected at the Salt River shops in Cape Town.[1][3][4][5]
If the same classification practice as that which was used for Garratt and Mallet locomotives had been followed, the Classes GH and U Union Garratts should have been designated Class UA and Class UB respectively. During the design phase of the two Union Garratt types, they were designated classification letters in the regular SAR Garratt range as Classes GH and GJ respectively. When orders were placed with the manufacturers, however, the Class designation of the Class GH was retained while that of the Class GJ Double Prairie type was changed to Class U. The reasoning behind this inconsistency is not known.[6][7]
Characteristics
The locomotives were superheated and had round-topped fireboxes, bar frames, Walschaerts valve gear and Z-ported cylinders with short-lap, short-travel valves. The design of the two Union Garratt types deviated from the Garratt principle, the patent of which was held by Beyer, Peacock and Company, and the end results were hybrid locomotives, part Garratt and part Modified Fairlie. The front end of the locomotive was of a typical Garratt arrangement with a water tank mounted on the front engine unit's frame, while the rear end was constructed in the Modified Fairlie fashion with the coal bunker mounted on a rigid extension of the locomotive's main frame and with the pivoting rear engine unit positioned beneath the coal bunker.[1][5][8]
Since the rear bunker carried only coal, an additional large underbelly water tank under the boiler compensated for the resulting diminished water capacity. All the engine's water was carried in the front bunker tank and in the underbelly water tank, with a combined capacity of 6,000 imperial gallons (27,000 litres), while the rear bunker had a coal capacity of 13 long tons 10 hundredweight (13.7 tonnes). The main frame therefore carried the smokebox, boiler, firebox, cab, coal bunker, as well as the underbelly water tank.[1][2][5]
The Class GH were massive and powerful locomotives and, having been designed for passenger service, were built for speed with their large 60 inches (1,524 millimetres) diameter coupled wheels. With their 60 square feet (5.6 square metres) firegrates, they were equipped with mechanical stokers of the duplex type. One reason which was put forward for the construction of the rear end of the Union Garratts on the Modified Fairlie principle was to enable their coal bunkers to be rigidly in line with their boiler frames to ensure a satisfactory arrangement for the installation of mechanical stokers. The subsequent designs of the Classes GL and GM Garratts showed that this precaution was unnecessary.[1][2]
Shortcomings
The Modified Fairlies and the Union Garratt variations of it were not successful in South Africa and they suffered from the same shortcomings.[1]
On the Union Garratts, as on the Modified Fairlies, the frames were prone to metal fatigue and cracking, brought about by the long frame overhang at the rear beyond the engine unit pivot centre. The overhang, laden with the coal bunker which extended completely beyond the rear engine unit's pivot centre was subjected to severe vertical oscillation while the locomotive was in motion and this led to structural weakening of the frame over time.[1][6]
In addition, since the coal bunker was mounted on the frame instead of on the engine unit, the rear pivot bearings were subject to quite rapid wear since they carried a considerable additional vertical load compared to those on a purebred Garratt. As was the case with the Modified Fairlies, this resulted in increased frequency of maintenance and as a consequence, increased operating cost.[1][5][6]
Service
The Class GH was acquired for working the named fast passenger trains of the era, the Union Express and Union Limited, and was initially shedded in Cape Town. The service career of the Class GH had a rough start, however, since on the first trip it was discovered that it exceeded the loading gauge in width. It returned to Salt River minus its steps and sundry fittings after having scraped the platforms of every station along its route. Considerable modifications had to be carried out before the two locomotives could be placed back in regular service.[1]
The Class GH made several trips working the Union Express out of Cape Town and was capable of taking the train up Hex River Railpass without a banker, but they were not as successful as had been hoped and they were soon taken off that duty. Their mechanical stokers also proved to be troublesome and were eventually removed. They were transferred to Natal and worked on the Natal mainline north of Glencoe for the rest of their service lives. Both were withdrawn from service by 1958.[2][5][8]
Illustration
- Class GH Union Garratt staged at Glencoe, Natal, c. 1950
References
- ^ a b c d e f g h i Holland, D. F. (1972). Steam Locomotives of the South African Railways. Vol. 2: 1910-1955 (1st ed.). Newton Abbott, England: David & Charles. pp. 56–57. ISBN 978-0-7153-5427-8.
- ^ a b c d Espitalier, T.J.; Day, W.A.J. (1945). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VII - South African Railways (Continued). South African Railways and Harbours Magazine, December 1945. p. 969.
- ^ a b South African Railways & Harbours/Suid Afrikaanse Spoorweë en Hawens (15 Aug 1941). Locomotive Diagram Book/Lokomotiefdiagramboek, 3'6" Gauge/Spoorwydte. SAR/SAS Mechanical Department/Werktuigkundige Dept. Drawing Office/Tekenkantoor, Pretoria. p. 32.
- ^ a b South African Railways & Harbours/Suid Afrikaanse Spoorweë en Hawens (15 Aug 1941). Locomotive Diagram Book/Lokomotiefdiagramboek, 2'0" & 3'6" Gauge/Spoorwydte, Steam Locomotives/Stoomlokomotiewe. SAR/SAS Mechanical Department/Werktuigkundige Dept. Drawing Office/Tekenkantoor, Pretoria. p. 32.
- ^ a b c d e f Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. p. 93. ISBN 0869772112.
- ^ a b c Durrant, AE (1989). Twilight of South African Steam (1st ed.). Newton Abbott: David & Charles. p. 31. ISBN 0715386387.
- ^ Drawing: 2-6-2-2-6-2 Type Garratt Engine, Class GJ (Ordered as Class U). S.A.R. Mechanical Department, Drawing Office, Pretoria, 29-10-25. Approved by F.R. Collins, Chief Mechanical Engineer, 31-10-25. (Class U 2-6-2+2-6-2 drawing).
- ^ a b Soul of A Railway, System 1, Part 2: Cape Town to Wellington. Caption 3. (Accessed on 26 November 2016)
- v
- t
- e
- SAR Class ES
- SAR Class ES1
- SAR Class Exp-AC
- SAR Class 1E
- SAR Class 2E
- SAR Class 3E
- SAR Class 4E
- SAR Class 5E s1
- SAR Class 5E s2
- SAR Class 5E s3
- SAR Class 5E1 s1
- SAR Class 5E1 s2
- SAR Class 5E1 s3
- SAR Class 5E1 s4
- SAR Class 5E1 s5
- SAR Class 6E
- SAR Class 6E1 s1
- SAR Class 6E1 s2
- SAR Class 6E1 s3
- SAR Class 6E1 s4
- SAR Class 6E1 s5
- SAR Class 6E1 s6
- SAR Class 6E1 s7
- SAR Class 6E1 s8
- SAR Class 6E1 s9
- SAR Class 6E1 s10
- SAR Class 6E1 s11
- SAR Class 7E
- SAR Class 7E1
- SAR Class 7E2 s1
- SAR Class 7E2 s2
- SAR Class 7E3 s1
- SAR Class 7E3 s2
- Spoornet Class 7E4
- SAR Class 8E
- SAR Class 9E s1
- SAR Class 9E s2
- SAR Class 10E
- SAR Class 10E1 s1
- Spoornet Class 10E1 s2
- SAR Class 10E2
- SAR Class 11E
- SAR Class 12E
- Spoornet Class 14E
- Spoornet Class 14E1
- TFR Class 15E
- Spoornet Class 16E
- Spoornet Class 17E
- Spoornet Class 18E s1
- TFR Class 18E s2
- TFR Class 19E
- TFR Class 20E
- TFR Class 21E
- TFR Class 22E
- TFR Class 23E